彎曲度：工字鋼高度小于或等于400MM時，每米彎曲度不得大于1.5MM，總彎曲度不得大于總長度的0.15%。高度大于400MM時，每米彎曲度不得大于1.0MM，總彎曲度不得大于總長度的0.1%。

Bending degree: when the height of the I-steel is less than or equal to 400MM, the bending degree of each meter must not be more than 1.5MM, and the total bending degree should not be more than 0.15% of the total length. When the height is greater than 400MM, the bending degree of each meter must not be more than 1.0MM, and the total bending degree should not be more than 0.1% of the total length.

工字型鋼不論是普通型還是輕型的，由于截面尺寸均相對較高、較窄，故對截面兩個主袖的慣性矩相差較大，因此，一般僅能直接用于在其腹板平面內受彎的構件或?qū)⑵浣M成格構式受力構件。

I-steel whether ordinary or light, because the section size are relatively high and narrow, so the moment of inertia of the main secti of the two sleeve is large, therefore, generally only can be directly used in the web plane bending member or the of lattice stress components.

薄板的寬度為500~1500毫米；厚的寬度為600~3000毫米。薄板按鋼種分，有普通鋼、鋼、合金鋼、不銹鋼、工具鋼、耐熱鋼、軸承鋼、硅鋼和工業純鐵薄板等。

The width of the thin plate is 500~1500 mm, and the thickness is 600~3000 mm. The sheet is divided by steel, including ordinary steel, high quality steel, alloy steel, spring steel, stainless steel, tool steel, heat resistant steel, bearing steel, silicon steel and industrial pure iron sheet.

細木工板握螺釘力好，強度高，具有質堅、吸聲、絕熱等特點，而且含水率不高，在10%—13%之間，加工簡便，用途為廣泛。

The woodworking board has good grip strength, high strength, strong quality, sound absorption, insulation and other characteristics, and water content is not , between 10% - 13%, easy processing, the most widely used.