在安裝時，嚴禁用鐵錘等擊打，防止軸向力或徑向力過大損壞軸承或齒輪。一定要將安裝螺栓旋緊之后再旋緊緊力螺栓。

At the time of installation, it is strictly prohibited to use a hammer, such as a hammer, so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.

在輸出軸上安裝傳動件時，不允許用錘子敲擊，通常利用裝配夾具和軸端的內(nèi)螺紋，用螺栓將傳動件壓入，否則有可能造成減速機內(nèi)部零件的損壞。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the transmission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

我們要購買減速機的首要步，首先要確定一點，我們購買的目的。對于減速機的分類，細化開來，有擺線針輪減速機，行星齒輪減速機和蝸輪蝸桿減速機等。還有使用較少的諧波齒輪減速機、滾子凸輪減速機、超環(huán)面蝸桿減速機等等。

We want to buy the first step of the reducer, first of all to determine a point, the  of our purchase. For the reducer of classification, refined, there are cycloid gear reducer, planetary gear reducer and worm gear reducer and so on. There are also less harmonic gear reducer, roller cam reducer, toroidal worm reducer and so on.