減速機的主要特點是具有反向自鎖功能，可以有較大的減速比，輸入軸和輸出軸不在同一軸線上，也不在同一平面上。但是一般體積較大，傳動效率不高，精度不高。

The main feature of the reducer is a reverse self lock function, which can have a larger reduction ratio. The input shaft and output shaft are not on the same axis, nor on the same plane. But the general volume is large, the transmission efficiency is not high and the precision is not high.

在安裝時，嚴禁用鐵錘等擊打，防止軸向力或徑向力過大損壞軸承或齒輪。一定要將安裝螺栓旋緊之后再旋緊緊力螺栓。

At the time of installation, it is strictly prohibited to use a hammer, such as a hammer, so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.

在電機與減速機連接前，應先將電機軸鍵槽與緊力螺栓垂直。為保證受力均勻，先將任意對角位置的安裝螺栓旋上，但不要旋緊，再旋上另外兩個對角位置的安裝螺栓后逐個旋緊四個安裝螺栓。

Before connecting the motor to the reducer, the key slot of the motor shaft should be perpendicular to the tightening bolt first. To ensure uniform force, screw the mounting bolts at any diagonal ition first, but do not tighten them. Then screw the mounting bolts on the other two diagonal iti, and tighten the four mounting bolts one by one.

減速機與工作機的聯接：減速機直接套裝在工作機主軸上，當減速機運轉時，作用在減速機箱體上的反力矩，又安裝在減速機箱體上的反力矩支架或由其他方法來平衡。機直接相配，另一端與固定支架聯接.

The connection between the reducer and the working machine: the reducer is directly installed on the main shaft of the machine, when the reducer operates, the torque acting on the gearbox body is installed on the reverse torque support on the reduction box body or by other methods to balance. The machine is directly matched and the other end is connected with the fixed support.