特別是輸出輥道，過去多采用上述方法對中，但是近有把輥距縮小的傾向，因而采用后一種斜輥布置方式的輥道正在減少。這是為了在軋制薄規(guī)格的帶鋼時避免使帶鋼在輥道上因終軋速度高而造成折疊。此外，對于輥道的速度和輥子直徑也要充分考慮好。

In particular, the output roller table used to use the above methods in the past, but recently there is a tendency to narrow the distance between rolls. Therefore, the roller table with the latter one is decreasing. to avoid folding the strip on a thin strip of strip to avoid the high finishing speed of the strip on the roller. In addition, the speed of the roller and the diameter of the roller should be fully cidered.

用這種支架時，輥子安裝完畢需用鋼絲進行鎖緊（即相鄰3～5個輥子軸用鋼絲串在一起）。輥子Φ155的支架采用槽鋼，輥子軸用壓板和螺栓固定在槽鋼翼緣上。

When the bracket is used, the roller is installed with the steel wire to be locked (that is, the 3~5 roller shafts are strung together with steel wire). The support of the roller 155 is used in the channel steel, and the roller shaft is fixed on the flange of the channel steel with the press plate and bolt.

對于大型軋機來說，尤其是熱軋機必須用動力傳動輥道。多的還是集體傳動式，特別是長度不大而軋件斷面很大時，適宜用集體傳動。單獨傳動輥道通常用于長距離的軋件的傳送。

For large rolling mills, in particular, the hot rolling mill must be powered by a power drive roller. The most important is the collective transmission type, especially when the length is small and the section of the workpiece is very large, it is suitable for the use of collective transmission. The single drive roller is usually used for the transmission of long distance parts.